Where should I install my Hive Leak Sensor?

Your Hive Leak Sensor should be installed on your mains water pipework, as close to the internal stop tap as possible and before the pipework splits to supply other areas of your home. This is to ensure that the leak sensor is monitoring your entire mains water pipework. 

Important: The leak sensor must be fitted inside in a heated part of your home and not outside.

Once you've found your stop tap, then install your Hive Leak Sensor on the ‘home’ side of your stop tap and before any branches on the mains water pipework. 
For help on where to install your leak sensor, check out our handy video below.

Feedback and Knowledge Base